if you use thick jails for max security, what's the fastest way to set them up? i clone the extracted base, but then i copy the jail specific fs layer in, then i run a setup bash script on the jail. any faster better way?

kerneldove: iocage+provisioning script?

kerneldove: Lately, pkg installs seem terrifically quick. I'm just doing that now instead of zfs send/receive of a base jail.

imo: bsdinstall jail /path/to/jail

how does bsdinstall jail work bsdrobert?

kerneldove: Right, I forgot - I wrote this up recently: wiki.freebsd.org/MasonLoringBliss/PkgBaseChroot

The man page probably explains it better than I can, but it installs a base system to the given path and also sets up some basic configuration that the installer does. I've only used it once.

kerneldove: script it :)

i have a year ago laptop, amd zen5, replaced the wifi mediatek->ax210, i recently i have used drm-kmod pkg built, and at using 15.1 instlaller-memstick >packages+gpu+drm-kmod, leaat kldload amdgpu conosle is fine now, i then try to installed 15.1 and installer goes auto wifi and it just stuck, used wifi manually, same again, i tried

shell->ifconfig->wpa_suppicant...etc,exit trying installer and it redo manually, seems doing that, after the disk setup, it wifi ssid is down again, and back to to start -> repeat, i tried installer without internet and it still needs internet to install,

or use a jail maanger

manager*

bastille is popular: bastillebsd.org

quickrr: try installing with ethernet, 802.11ax is still unsupported (afaik), however ax210 I do believe is supported firmware wise, however only for 802.11ac (and older). But the support for these is flaky sometimes

its why I use a wifi card which is over a decade old, it just works :p

(okay thats a lie, even with older hardware freebsd wifi will randomly break)

hmmm i assumed ax210 was decent, ax201 are fine then? or 9*/7*?

ax200* (ignore ax201 for intel)

ah my bad ax200 are just bluetooth